Energy Storage Maintenance
Fractal can provide on-site preventative maintenance, inspection, testing and training at competitive rates. Contact us today for a quote.
On-Site Maintenance Support Options
Preventative Maintenance
Annual Onsite Inspections and Preventative Maintenance (required and scheduled) on the following equipment:
- Battery System
- Power Conversion System (PCS)
- HVAC
- Battery Enclosure
- Auxiliary Components (HVAC, Fire Suppression, etc.
Required and scheduled maintenance:
- Cleaning and calibration
- Consumable parts replacement
Recurrent Training
Provide periodic training to operators, managers and on-site personnel:
- Introduction and Safety
- General System Overview and operation
- Fire Detection and Suppression
- Customer Site Specific Equipment
- Site Controller(s)
- Remote Software
- Alarms
- Preventative Maintenance and Customer Support
- Site Tour of Software
- Site Tour of Hardware
Corrective Maintenance
- Facilitate and manage any necessary corrective maintenance. This includes managing vendor relationships regarding warranty support and fulfillment.
Inspection Reporting
- Provide detailed summaries of all maintenance items performed during annual maintenance visit for all equipment as described in the applicable O&M manuals.
Annual Preventative Maintenance
Corrective Maintenance
System
- Power and energy capacity test
- RTE test
- Fire suppression test smoke test
Enclosure
- Inspect and condition door seals and verify integrity
- Inspect for roof damage
- Inspect for signs of leaks or water damage
- Inspect the exterior of the container to verify calk, paint and surface
HVAC
- Clean to remove soiling by vacuuming
- Clean housing
- Clean of dust and debris
- Check and clean the primary and secondary condensate drains
Fire Suppression
- Inspect panel, tank, connectors, and piping
- Check tank pressure
- Certify the fire suppression system (if required by local fire department)
IT Hardware
- Visually inspect cables, cable connections and general integrity and cleanliness
Inspection Reporting
Battery
- Check and calibrate the temperature sensor
- Check and calibrate the humidity sensor
- Check information logged by EMS
- Visual inspection of the battery room for leakage and condensation; check battery connections and torques
- SOH Calibration
- Cell Balancing
- Voltage & Temperature Uniformity Check
- DC Contactor Operation Verification
- Voltage Sensor Accuracy Check
- 24V Aux Power Accuracy Check
Inverters
- Inspect for heat stress, discoloration, deformation
Auxiliary Equipment
- Clean and inspect auxiliary panels, check for loose connections, overheating or abnormal conditions
- Visual inspection of UPS, verify functionality, battery check and voltage measurements